Classic Cornice

Classic Cornice looks fantastic in a traditionally styled kitchen.   Door designs like Annabelle, Calcutta, Prague, Victoria, etc, really compliment the moulded design.   When fitted the Classic Cornice adds 62mm to the height of the unit. Check Availability

Classic Cornice is supplied in 2.5m lengths. Price: £35.00 per 2.5m length. Gloss is NOT available.

---

Universal Cornice Pelmet

Universal Cornice Pelmet can be used as both cornice and pelmet.  A simple but effective trim to finish off your wall units, especially when it is combined with a simple kitchen door design like any of our Shaker ranges or plain designs like Premier Slab or Premier Duleek, etc. When fitted it stands/drops 33mm or 50mm from the unit. Check Availability

Universal Cornice Pelmet is supplied in 2.5m lengths. Price: £30.00 per 2.5m length for non-gloss finishes Price: £39.00 per 2.5m length for gloss finishes

---

Tangent Cornice

The Tangent Cornice is a modern alternative to the Traditional Cornice above.  Protruding at roughly 45 degrees from the unit and 50mm high this smooth design much more compliments most kitchen door designs.   Check Availability

Tangent Cornice is supplied in 2.5m lengths. Price: £30.00 per 2.5m length for non-gloss finishes Price: £39.00 per 2.5m length for gloss finishes

---

Tangent Pelmet

Tangent Pelmet is a modern alternative to the Traditional Pelmet above.  It is designed to match the Tangent Cornice. When fitted the Tangent Pelmet drops 60mm from the unit.   Check Availability

Tangent Pelmet is supplied in 2.5m lengths. Price: £30.00 per 2.5m length for non-gloss finishes Price: £39.00 per 2.5m length for gloss finishes

---

Plinth (kickboards)

Plinths, also known as 'Kickboards', are the skirting around the bottom of the units. Plinth is available in ALL finishes.

Plinth is supplied in 2.5m lengths and is 150mm in height. Price: £30.00 per 2.4m length for non-gloss finishes Price: £39.00 per 2.4m length for gloss finishes

---

Edging Tape

Edging Tape can be applied to the front edges of existing kitchen cupboards or panels so that they are the same colour as your new kitchen doors and drawer fronts. The Edging Tape is supplied with heat activated glue on one side. You simply hold the edging tape in place and press an old clothes iron against it. Once the glue has set you can trim the excess tape off using a sharp blade.  Check Availability

Edging tape is supplied in a 50 metre roll and is 22mm in width.  Price: £22.00 per roll for non-gloss finishes Price: £29.70 per roll for gloss finishes.

---

Plain Panels

Plain Panels are available made to measure, any size (min 50mm wide). The face and all four edges are vinyl wrapped just like the kitchen doors. Also the same thickness as the doors at 18mm these panels are perfect for use as end panels and infill (filler) panels. Please note that the panels have a tiny 2mm radius on the edges and corners. Tongue and Groove effect panels are also available - see below. Plain Panels available in ALL finishes. Plain Panels available up 2550mm high by 1200mm wide. Plain Panels also available at 22mm thick if requested (extra 20%).

£80.00 per sq. metre for any non-gloss finish. £92.00 per sq. metre for any TRUE-MATT finish. £104.00 per sq. metre for any high-gloss finish. Below are example prices. Panels can be made to any size what-so-ever. Size (in mm) Finish Price 1000 x 500 Non-gloss £40.00 1000 x 500 High-gloss £52.00 1500 x 150 Non-gloss £18.00 1500 x 150 High-gloss £23.40

---

'L' Shaped Corner Post

'L' Shaped Corner Posts are normally required when two kitchen doors are installed in a corner unit. The height and width of a corner post can be made to any size. Popular widths are: 30mm x 30mm and 40mm x 40mm. (Measured at the back of the 'L' shape') Corner Posts are available in ALL finishes.

Price: £22.00 per 720mm length for non-gloss finishes Price: £29.70 per 720mm length for gloss finishes

---

Hinge with backplate

107 degree CLIP ON hinges, opening a little more than a right angle, are the most common type of hinges used in a kitchen.   These are made by Hafele and have a Lifetime guarantee.

Price: £2.50 for one hinge (non soft close) with backplate. £5.00 for one hinge (with integrated soft close) with backplate.

---

Wide opening hinge with backplate

155 degree CLIP ON hinges open the door fully, therefore allowing more access to the wardrobe.  These are made by Hafele and have a Lifetime guarantee.

Price: £5.00 for one wide-opening hinge (non soft close) with backplate. £8.00 for one wide-opening hinge (with integrated soft close) with backplate.

---

Hinge Holes

Hinge holes are 35mm in diameter and are found in the back of kitchen doors. Hinge holes can be drilled in standard positions or you can specify how far up or how far down the door you would like the holes. Please note that the distance from the inside edge of the door to the centre of the hole is 22.5mm. This cannot be changed.

Price: £1.20 per hole drilled

---

T & G Panels

T & G (Tongue and Groove effect) Panels are available made to measure. The face and all four edges are vinyl wrapped just like the doors. Also the same thickness as the doors at 18mm panels are perfect for use as end panels and infill (filler) panels. Please note that the panels have a tiny 2mm radius on the edges and corners. T & G panels are available in ALL finishes. Plain Panels also available at 22mm thick if requested (extra 20%).

T & G Panels are charged at: £88.00 per sq. metre for any non-gloss finish. £101.20 per sq. metre for any TRUE MATT finish. £114.40 per sq. metre for any high-gloss finish.

---

Open End Display Unit

Open End Display Units are used as an effective feature at the end of a run of units.  Instead of a flat end panel the addition of an Open End Display Unit creates more storage or display space. Open End Display Units are available in any size. The measurements that are required are height, width and depth. Open End Display Units are available in ALL finishes. Open End Display Units are supplied unassembled and without fixings.

Price From £50.00

---

Matching Vinyl Sheet (Unglued Vinyl)

Our Matching Vinyl Sheet is specifically designed for flat, vertical surfaces such as the sides of cupboards or infil sections. The vinyl is 1300mm wide and you can order it by the metre for any continuous length you need. For installation, we recommend using a double-sided adhesive film (shown below) Alternatively, you can use a solvent-free adhesive. Matching Vinyl Sheet is available in ALL finishes.

Non-Gloss finish: £23.50 per linear metre. True-Matt finish: £27.03 per linear metre. High-Gloss finish: £31.73 per linear metre. Our Sample Swatches are off-cuts of the Matching Vinyl Sheet.

---

Double-sided Adhesive Film

Easy to use: 1) Cut the adhesive film roughly to size. 2) Peel off the CLEAR backing paper. Any creases will disappear when this backing is removed. 3) Apply the adhesive film to the cupboard side or panel, smoothing as you go. 4) Trim excess using a Stanley blade. 5) Cut the Matching Vinyl Sheet roughly to size. 6) Remove the yellow backing paper from the adhesive film, exposing the sticky side. 7) Apply the Matching Vinyl Sheet and trim the excess with a Stanley blade.

Our Double-sided Adhesive Film is 610mm wide and is supplied by the metre in a continuous length. Contact us if you require a free, small sample to test with. Price: £8 per linear metre.

---